Initial setup went fine. I installed NIC & Graphic drivers, rebooted, installed AV, MBAM & MOBO utililites, - rebooted and now I can't get the input devices to work. I'm using a Logitech keyboard mouse combo that usually needs the Unify software (not installed, didn't need it it seemed) but it was working all through install. I switched USB ports for the receiver but no go. I plugged in wired USB mouse & keyboard and it didn't work. I booted to safe mode and both sets didn't work.
Both sets work fine in BIOS but after that it doesn't. When I press F8 during boot I was given the choice for last known good config, booted to safe mode, and now that option is gone.
Anyone know what might cause this? What steps should I take now. I might just try reinstall and see if it happens again:sad:
Both sets work fine in BIOS but after that it doesn't. When I press F8 during boot I was given the choice for last known good config, booted to safe mode, and now that option is gone.
Anyone know what might cause this? What steps should I take now. I might just try reinstall and see if it happens again:sad: