I just wanted to know on how to make more than my computer to show up on my network. I am mostly on my Wireless network connection a lot, but so much as Lan which is hard-wired. Now I would just like to see on how to get some other computers on my own network, be it wireless or Lan. I know this command I put into the command prompt which is the Net View command. I go to my prompt and type in net view, and it says the command has completed successfully, and my computer name is there as well.
But no other computers are there at all, except for my own. So why is this for? I would really appreciate it to see some other computer names listed there on my command prompt, when I type in Net View, but I just see my own name there! That is no good. So is there any way to figure this out? Do you have any ideas or solutions for me that will work. And also I use Cain and Able a lot to check other computers and their IP's. So when I click on ARP Poisoning, that won't work either. I tried on my wireless and my Lan, but I had no luck.
Actually I am not sure if I tried Lan or not, I will have to look into that. The ARP Poisoning I think actually works, I can get it to say "Posioning," but then it just sits there and does nothing. Also, at first I use the sniffer to start off. And when I scan my wireless network, it just shows up only my router gateway IP and my older Dell desktop IP, and that is it. It only shows like 2 IP's in my network. So something is not right here at all.
Do I need to buy a special Usb stick called Airpcap NX wireless packet capture? I looked online and I saw that this was really expensive, so I do not think it is worth it. Well anyway, so that is about it. So I would like to know if it is possible to get some more computers and their IP's into my wireless network or my Lan. Because I have no idea on how to do this. And I know that this process is possible, but I can't figure out on how to do it. And this goes for entering the Net View command into the command prompt. So please give me some help and adivce, any help would be greatly appreciated. So please get back to me as soon as you can. So thank you very much! :confused: :cry:
But no other computers are there at all, except for my own. So why is this for? I would really appreciate it to see some other computer names listed there on my command prompt, when I type in Net View, but I just see my own name there! That is no good. So is there any way to figure this out? Do you have any ideas or solutions for me that will work. And also I use Cain and Able a lot to check other computers and their IP's. So when I click on ARP Poisoning, that won't work either. I tried on my wireless and my Lan, but I had no luck.
Actually I am not sure if I tried Lan or not, I will have to look into that. The ARP Poisoning I think actually works, I can get it to say "Posioning," but then it just sits there and does nothing. Also, at first I use the sniffer to start off. And when I scan my wireless network, it just shows up only my router gateway IP and my older Dell desktop IP, and that is it. It only shows like 2 IP's in my network. So something is not right here at all.
Do I need to buy a special Usb stick called Airpcap NX wireless packet capture? I looked online and I saw that this was really expensive, so I do not think it is worth it. Well anyway, so that is about it. So I would like to know if it is possible to get some more computers and their IP's into my wireless network or my Lan. Because I have no idea on how to do this. And I know that this process is possible, but I can't figure out on how to do it. And this goes for entering the Net View command into the command prompt. So please give me some help and adivce, any help would be greatly appreciated. So please get back to me as soon as you can. So thank you very much! :confused: :cry: